54
3. Recorded Speech Audiometry to Headphones
3.1 Set Up
f Connect a CD, tape player, or other sound source to the LINE IN
jack socket; refer to Section 2.7 of this operating manual.
f Press SPEECH and use Softkey 1 to ensure that ‘LINE’ is displayed
in capitals (indicating that the line input is selected).
f The line input is initially routed to the left earphone. To select the
right earphone press RIGHT.
f The input signal is adjusted in 1dB steps by use of the MASK
rotary control.
f Play the 1kHz calibration tone on the recorded material and
adjust the input signal such that the LEVEL dB bar graph
reads 0dB; the headphone output measured in an IEC 318
ear simulator will now be 89dBSPL for a setting of 70 dBHL.
f The output level is controlled in 5dB steps by the SIGNAL control.
3.2 Procedure
As described in 1.2 except that the operator plays the recorded
material to the subject.
To Next Page
Loading...
