SED2 AOP Operating Instructions
28 Siemens Building Technologies
3. The AOP displays a set day/date screen and highlights the first field (day of week).
Use
and to scroll through and highlight the desired day of week.
Press
to confirm the entry.
The cursor advances to the first date field (day of month).
4. Use
and to scroll through the digits until the desired day of the month (01-31)
displays.
Press
to confirm the entry.
The cursor advances to the next date field (month [01-12], and then year [2000-2250]).
Repeat this step until the desired date (day-month-year) is set.
5. Press and hold the
key to accept the Day/Date settings and to return to the setup menu.
AOP Reset
:$51,1*
The AOP reset function enables the deletion of all parameter sets and settings, internal
faults, and message logs stored in the AOP.
1. Use
and to highlight the AOP Reset option on the setup menu.
Press
to confirm the selection.
The AOP displays an AOP reset screen.
2. Use
and to select ON or OFF to enable or disable the AOP reset function
respectively.
Press
to confirm the selection.
Press
to cancel this selection and to return to the setup menu.
3. When you select OFF, the AOP disables the AOP reset function and returns to the setup
menu.
When you select ON, the AOP displays the parameter reset screen.
Press
to confirm the AOP reset function and to delete all parameter sets, internal faults,
and message logs. The AOP then restarts.
Press
to cancel this selection and to return to the setup menu without deleting any
information. The AOP then restarts.
NOTE: Simultaneously press and at any time to display relevant help screens.
To Next Page
Loading...
Need help?
General
