Siemens Simatic 6ES7132-4HB01-0AB0 User Manual

Properties
1.1 Digital electronic module 2RO NO DC24..120V/5A, AC24..230V/5A (6ES7132-4HB01-0AB0)
Digital electronic module 2RO NO DC24..120V/5A, AC24..230V/5A (6ES7132-4HB01-0AB0)
10 Manual, 04/2007, A5E01077282-01
Voltages, currents, potentials
Rated supply voltage L+
(from the power module)
24 VDC
Reverse polarity protection Current per channel Yes
• Up to 50°C
Max. 5 A
• Up to 60°C
Max. 4 A
Electrical isolation
• Between the channels
Yes
• Between the channels and backplane bus
Yes
• Between the channels and supply voltage
Yes
• Between the supply voltage and backplane
bus
Yes
Permissible potential difference
• Between the supply voltage and backplane
bus
75 VDC / 60 VAC
• Between channels and backplane bus
240 VAC
• Between channels and supply voltage
240 VAC
Insulation tested Yes
• Between the supply voltage and backplane
bus
500 VDC
• Between channels and backplane bus
1500 VAC
• Between channels and supply voltage
1500 VAC
Current consumption
• From the power supply L+
Max. 30 mA
Power dissipation of the module Typically 0.6 W
Status, interrupts, diagnostics
Status display Green LED per channel
Diagnostics function No
Data for selecting an actuator
Output current
• Continuous thermal current
Max. 5 A
• Minimum load current
8 mA
• Minimum voltage
17 V
Connecting two outputs in parallel
• For redundant triggering of a load
No
• To increase performance
No
Control of a digital input Yes
Switch rate
• For resistive load
2 Hz
• On inductive load
0.5 Hz
• For lamp load
2 Hz
Limitation (internal) of the voltage induced on
circuit interruption
No
Short-circuit protection of the output
1
No
1
The relay outputs must be fused externally with 6 A.

Siemens Simatic 6ES7132-4HB01-0AB0 Specifications

General

Brand	Siemens
Model	Simatic 6ES7132-4HB01-0AB0
Category	Control Unit
Language	English