Mounting position
The active field distributors can be installed in any orientation.
Mounting system
The active field distributors can be screw-mounted onto a flat, vibration-free surface with
sufficient load bearing capacity. The modules can also be installed on a mounting rail using
an adapter.
For trouble-free installation of the modules, a clearance of 60 mm must be maintained on their
side and below them.
For detailed information on installation, refer to Operating Instructions
DP/PA Coupler, Active
Field Distributors, DP/PA Link and Y Link
.
See also
Active field distributor for connecting FF segments (Page 15)
5.3 Installing the Compact FF Link
5.3.1 Installing the Compact FF Link for single-channel operation
Introduction
The following application is available for the configuration variant with one Compact FF Link:
● Single-channel operation
Configuration with the mounting rail "for standard configuration"
Basic installation steps
Carry out the following installation steps in the order given:
1. Install the mounting rail
2. Install the module on the mounting rail
Components required
Required components for single-channel operation (1 x Compact FF Link)
● Mounting rail "for standard configuration"
● Compact FF Link
Mounting
5.3 Installing the Compact FF Link
Compact FF Link
26 Operating Instructions, 03/2015, A5E35651552-AA
To Next Page
Loading...
