Siemens SIMATIC Compact FF Link - Page 80

WARNING
Installation Instructions according cULus
WARNING – Explosion Hazard - Do not disconnect while circuit is live unless area is known
to be non-hazardous.
WARNING – Explosion Hazard - Substitution of components may impair suitability for Class
I, Division 2 or Class I, Zone 2
This equipment is suitable for use in Class I, Division 2, Groups A, B, C or D; Class I, Zone
2, Group IIC, or non-hazardous locations only.
FM approval
FM
APPROVED
Factory Mutual Research (FM) in accordance with
Approval Standard Class Number 3611, 3600, 3810
APPROVED for use in
● Class I, Division 2, Group A, B, C, D Tx;
● Class I, Zone 2, Group IIC Tx
Tick mark for Australia and New Zealand
The components described satisfy the requirements of the following standards:
EN 61000-6-4: 2007 + A1: 2011
IEC 61131
The components described satisfy the requirements and criteria of the following standards:
IEC 61131‑2 (Programmable logic controllers – Part 2: Equipment requirements and tests)
PROFIBUS standard
The components described are based on the following standards:
IEC 61784‑1 CP 3/1
Technical data
12.1 General technical data
Compact FF Link
80 Operating Instructions, 03/2015, A5E35651552-AA