Mounting the CP 340
4.2 Installing and removing the CP 340
PtP coupling and configuration of CP 340
Manual, 04/2011, A5E00369892-03
91
4.2.2 Removal steps
To remove the CP 340
To dismount the CP 340 from the rack, proceed as follows:
1. Switch the CPU to STOP mode.
2. Open the front panel doors.
3. Detach the sub D connector from the integrated interface.
4. Undo the fastening screw on the module.
5. Swing the module off the rail, then take it out of the PLC.
To Next Page
Loading...
