Siemens SIMATIC NET SCALANCE W761-1 - DST Configuration

Configuring with Web Based Management
5.5 "System" menu
SCALANCE W760/W720 to IEEE 802.11n Web Based Management
150 Configuration Manual, 11/2014, C79000-G8976-C350-03
●
End Date
Shows the month, day and time for the end of daylight saving time.
●
Type
Shows how the daylight saving time changeover is made:
– Date
A fixed date is entered for the daylight saving time changeover.
– Recurring
A rule was defined for the daylight saving time changeover.
5.5.12.3
DST Configuration
On this page, you can configure the entries for the daylight saving time changeover. As
result of the changeover to daylight saving or standard time, the system time for the local
time zone is correctly set.
You can define a rule for the daylight saving time changeover or specify a fixed date.
Settings
Note
The content of this page depends on the selection in the "Type" box.
The
boxes "DST No.", "Type" and "Name" are always displayed.
●
DST No.
Select the type of the entry.
●
Type
Select how the daylight saving time changeover is made:
– Date
You can set a fixed date for the daylight saving time changeover.
This setting is suitable for regions in which the daylight saving time changeover is not
governed by rules.
– Recurring
You can define a rule for the daylight saving time changeover.
This setting is suitable for regions in which the daylight saving time always begins or
ends on a certain weekday.
●
Name
Enter a name for the entry.