Siemens SIMATIC NET SCALANCE W761-1 - Allowed Channels

Configuring with Web Based Management
5.6 "Interfaces" menu
SCALANCE W760/W720 to IEEE 802.11n Web Based Management
178 Configuration Manual, 11/2014, C79000-G8976-C350-03
5.6.2.4
Allowed Channels
Channel settings
For communication, a specific channel within a frequency band is used. You can either set
this channel specifically or configure so that the channel is selected automatically.
On this page, you specify which channels may be used for communication.
Description
Table 1 contains the following columns:
●
Radio
Shows the available WLAN interfaces in this column.
●
Use Allowed Channels only
If you enable the option, you restrict the selection of channels via which the AP or the
client is allowed to establish the connection.
In the following tables, you define the
– channels that the AP can use to establish a wireless cell when the "Auto" channel
setting is enabled.
– the channels on which the client searches for an AP.
The tables are divided up according to frequency bands.
If the option is disabled, the channels available based on the settings (country code,
antennas, transmit power etc.) are used.