Siemens SIMATIC OP7 User Manual

13
Temper. Set. 0.00°C
Humid. Set. 0.00 %
A2
Flashing cursor
To set the temperature (
1
)
To set the humidity % (
2
)
(1) See the temperature range in the chapter entitled “Technical specifications”
(2) See the humidity range in the chapter entitled “Technical specifications”
A3
Place the cursor as shown in order to
set a temperature value
Temp. gr. 20.00°C
Hum. gr. 0.00 %
2
0
ENTER
If you enter the wrong number, you will still have to press ENTER and then re-digit
the number.
Departure temperature
Temp. gr. 0.00°C min
Hum. gr. 0.00 RH%min
Warning!
in order to reach the
departure point, theses
values must be set to zero
(maximum speed).
A4
Temp. gr. = Temperature gradient
(0=maximum speed)
Hum. gr. = Humidity gradient
(0=maximum speed)
Temperature enab OFF
Humidity enab. OFF
- To enable or disable temperature
control
- To enable or disable humidity con-
trol
A5
SHIFT
Temperature enab. ON
Humidity enab. OFF
- Temperature control is enabled
ENTER
If you enter the wrong number, you will still have to press ENTER and then re-digit
the number.

Siemens SIMATIC OP7 Specifications

General

Brand	Siemens
Model	SIMATIC OP7
Category	Control Systems
Language	English