Siemens SIMATIC OP7 User Manual

34
4.5 HOW TO SAVE A PROGRAMME
It is extremely important to save the programme in the main memory
(MICRO PLC) in order to avoid accidental deletions due to blackouts or
to the machine being switched off.
Cycles Menu
Program edit : (1)
Loop table : (2)
Save program : (3)
Load program : (4)
Delete program : (5)
Ripetition : (6)
Ver. curr. progr. : (7)
to save the programme
Choice 3
Start progr. STOP
Monitoring : OFF
to save the current programme
SAVE PROGRAM
< ESC > Prev. menu
P2
P3
P4
P1
P5
Current program
will be saved
on position N° : _ _ 1
Save program OFF
P6
(*) 10 programmes can be saved in the main memory (Micro PLC)
The number of the first free position in the memory is visualized in this field; the programme can, in fact, only be saved in
the first free position. Make a note of the position in which the programme was saved. If there are no free positions, this
message will flash.
The LOOP table will be saved together with the programme.
ESC
Flash eprom full
<ESC> To exit
Proceed as follows:
ESC
to exit from this page
(*)
Move on to paragraph 4.8 “HOW TO DELETE A PROGRAMME”
SHIFT
P7
Current program
will be saved
on position N° : _ _ 1
Save program SAVE
this will flash
The programme is saved
SIEMENS
SIMATIC OP7
F1 F2 F3 F4
K1 K2 K3 K4
789
456
123
.
0 +/-
SHIFT
INS
DEL
HELP ENTER
ACX
ESC
MICRO
PLC
P8
ENTER

Siemens SIMATIC OP7 Specifications

General

Brand	Siemens
Model	SIMATIC OP7
Category	Control Systems
Language	English