15
Temp. gr. 1.00 °C min
Hum. gr. 0.00 RH%min
• Enter the temperature gradient but
leave the humidity gradient at 0 for
the time being.
A4
ENTER
If you enter the wrong number, you will still have to press ENTER and then re-digit
the number.
Temperature enab ON
Humidity enab. OFF
- To enable or disable temperature
control
- To enable or disable humidity
control
A5
SHIFT
- Temperature control is enabled
If you also wish to enable humdity
control, move the cursor to the line
below.
Temperature enab. ON
Humidity enab. ON
ENTER
If you enter the wrong number, you will still have to press ENTER and then re-digit
the number.
Dehumidification: OFF
Vibrator: OFF
Specimens: OFF
U.V. lamp.: OFF
A6
- Ignore these data for the time
being and move on to the next
page.
Water recharge: OFF
Not used: OFF
Not used: OFF
SP. hum. CTRL OFF
A7
SHIFT
Humdity slope control remains
switched off.
To improve the performance of the
system (experiment the setting)
ENTER
K1
TO VISUALIZE ON THE DISPLAY
• The key led light is switched on
• the machine starts up and carries out the set temperature slope with a 60% RH
humdity.
Once the set temperature values have been reached, the machine will continue
along these values.
K2
• To switch off (led light switched off)
• Press
Internal chamber data are visualized.
Temp. meas. 35 °C
Humid. meas. 60 %
To Next Page
Loading...
Need help?
General
