2
2-3
Programming Device PG 740
C79000-G7076-C742-01
With the keyboard open, you can incline the unit to any angle between 0 and
90° around the axis of rotation of its stand. Proceed as follows:
1. Swing the keyboard down.
2. Pull the extra support (Figure 2-3) out of the rear of the stand.
3. Incline the unit to the angle you prefer.
Figure 2-2 Changing the Angle of Inclination
!
Caution
Risk of injury!
There is a danger of the unit tipping over if it is set up without extra support
and at an angle of inclination of more than 15°. This could lead to personal
injury and also damage to the unit.
If the angle of inclination is greater than 15°, you must use the extra
slide-out support in the stand.
Changing the
Angle of
Inclination
Installing the PG 740
To Next Page
Loading...
