2
2-5
Programming Device PG 740
C79000-G7076-C742-01
You detach the keyboard as follows:
1. Grip the keyboard hinges in the stand behind the keyboard as shown in
Figure 2-4.
2. Pull the locks in the middle of the hinge assembly toward the keyboard.
3. Pull the keyboard up and out.
4. Set the keyboard down on a suitable surface, using the hinge assembly as
a stand.
5. Make sure the cable is not pinched or squashed in any way.
6. To attach the keyboard again, snap the keyboard hinges into the matching
receptacles in the stand.
The basic unit can be attached to a wall. Four drilled holes (6 mm diameter)
are provided in the base of the unit for this purpose.
345 mm
ø6
83 mm
Figure 2-5 Drilling Template for Wall Mounting
Wall Mounting
Installing the PG 740
To Next Page
Loading...
