6 Operation of the Application
6.1 “MC Watch” watch table
SINAMICS G120 as a Speed Axis on the S7-1500
V1.0a, Entry ID: 78788716
Copyright Siemens AG 2013 All rights reserved
6 Operation of the Application
6.1 “MC Watch” watch table
The program of the sample project consists only of the call of the blocks for the
motion control instructions.
The visualization of the blocks on the operator panel allows you to test the
individual functions and get to know their reactions.
Note
If you cannot or do not want to use an operator panel, you can also use the “MC
Watch” watch table created in the sample project.
To Next Page
Loading...
Need help?
General
