Siemens Simatic S7-300 - Page 5

Preface
CPU 31xC and CPU 31x, Technical data
Manual, Edition 08/2004, A5E00105475-05
v
Documentation classification
This manual is part of the S7-300 documentation package.
Name of the manual Description
YOU ARE READING the Manual
• CPU 31xC and CPU 31x, Technical data
Control and display elements, communication,
memory concept, cycle and response times,
technical data
Reference Manual
• CPU data: CPU 312 IFM – 318-2 DP
Control and display elements, communication,
memory concept, cycle and response times,
technical data
Operating Instructions
• S7-300, CPU 31xC and CPU 31x: Installation
Configuration, installation, wiring, addressing,
commissioning, maintenance and the test
functions, diagnostics and troubleshooting.
Installation Manual
• S7-300 Automation System: Installation: CPU
312 IFM – 318-2 DP
Configuration, installation, wiring, addressing,
commissioning, maintenance and the test
functions, diagnostics and troubleshooting.
System Manual
PROFINET System Description
Basic information on PROFINET:
Network components, data exchange and
communication, PROFINET I/O, Component
based Automation, application example of
PROFINET I/O and Component based
Automation
Programming Manual
From PROFIBUS DP to PROFINET IO
Guideline for the migration from PROFIBUS DP
to PROFINET I/O.
Manual
• CPU 31xC: Technological functions
• Examples
Description of the individual technological
functions Positioning, Counting. PtP
communication, rules
The CD contains examples of the technological
functions
Reference Manual
• S7-300 Automation System: Module data
Descriptions of the functions and technical data
of signal modules, power supply modules and
interface modules.
Instruction List
• CPU 312 IFM – 318-2 DP
• CPU 31xC and CPU 31x
List of CPU instruction resources and the
relevant execution times. List of executable
blocks.
Getting Started
The following Getting Started editions are available
as a collective volume:
• CPU 31x: Commissioning
• CPU 31xC: Commissioning
• CPU 31xC: Positioning with analog output
• CPU 31xC: Positioning with digital output
• CPU 31xC: Counting
• CPU 31xC: Rules
• CPU 31xC: PtP communication
• CPU 31x-2 PN/DP: Commissioning a
PROFINET IO subnet
The example used in this Getting Started
guides you through the various steps in
commissioning required to obtain a fully
functional application.