11. Continue following steps 8 and 9 until all output and input data areas are
defined.
This results in four configuration rows for this example:
Note
Be sure to use identical values for the start addresses of the output and input data
areas.
A total of 12 bytes (consistent) must be configured for the output data area, and 6
bytes (consistent) for the input data area.
Always select the "Consistency: All" option for all input and output data areas.
Additional Information
For information on programming safety-related master to I-slave communication,
refer to Section 1.2.6.
For information on master to I-slave communication, refer to the STEP 7 online
help.
Product Information for the S7 Distributed Safety, Configuring and Programming Manual
A5E00169432-02
11
To Next Page
Loading...
