1.2.20 Printing Out Project Data of the Safety Program
Printing Out Additional Project Data with S7 Distributed Safety V 5.2 + SP 1
In addition to the project data indicated in Section 5.11 of the manual, the following
project data are printed out for the safety program:
The version of the F-compiler that was used to compile the safety program is
printed out as an internal version ID.
•
•
•
•
•
For F_GLOBDB: absolute and symbolic address of the time of compilation and
of RLO 0 and RLO 1.
The time of compilation of the safety program is printed out.
The version of the F-compiler used to create the printout is indicated in the
footer.
A note is printed out if the amount of local data reserved for the safety program
has been exceeded.
Product Information for the S7 Distributed Safety, Configuring and Programming Manual
A5E00169432-02
61
To Next Page
Loading...
