Software Requirements for S7 Distributed Safety, V 5.2 + Service Pack 1
The following software package (at least) must be installed on the PC or
programming device:
STEP 7, V 5.1 + Service Pack 6 or higher or:
Please note that use of the following functions is possible only with higher STEP 7
versions:
Function Required STEP 7 Version
Modification of automatically assigned PROFIsafe target
addresses in HW Config
F submodules ET 200S
Fail-safe DP standard slaves
STEP 7, V 5.2
STEP 7, V 5.2 + Service Pack 1
Using F libraries created by the user STEP 7, V 5.2
Using safety-oriented I-slave to I-slave communication STEP 7, V 5.2 + Service Pack 1
Using a CPU 317F-2 DP STEP 7, V 5.2 + Service Pack 1
!
Safety Note
The use of the optional package S7 Distributed Safety, V 5.2 + Service Pack 1
with earlier versions of STEP 7 is not permitted.
Software Requirements for Configuring F-CPUs
The following software is required to configure F-CPUs for use in S7 Distributed
Safety:
F-CPU As of Order No. S7 Distributed Safety STEP 7
IM151-7 F-CPU 6ES7 151-7FA00-0AB0 V 5.2 V 5.2
CPU 315F-2 DP 6ES7 315-6FF01-0AB0 V 5.2 V 5.1 + Service Pack 6
CPU 416F-2 6ES7 416-2FK02-0AB0 V 5.2 V 5.2
CPU 317F-2 DP 6ES7 317-6FF00-0AB0 V 5.2 + Service Pack 1 V 5.2 + Service Pack 1
Product Information for the S7 Distributed Safety, Configuring and Programming Manual
4 A5E00169432-02
To Next Page
Loading...
