Siemens SIMEAS P 7KG7750 - Bus Specific Parameters

Parameters and Properties
16
Power Meter, SIMEAS P 7KG7750/55, Manual
E50417-B1076-C375-A3, Release 01.2009
2.1 Bus Specific Parameters
2.1.1 General
The following settings for the serial communication between the IEC 60870-5-103
master and the IEC 60870-5-103 slave have to be defined during parameterization of
the SIMEAS P50 device.
For parameterization of the bus specific parameters in SIMEAS P PAR from V1.40
please open the dialog box Device connection parameters (Fig. 2-1) using the menu
command:
Menu Device → Connection configuration → Edit.
Adjust the parameters in the dialog box Device connection parameters (Fig. 2-1):
Fig. 2-1 Dialog box Device connection parameters, from SIMEAS P PAR version 1.40
Note:
The use of the IEC 60870-5-103 communication protocol and configuration software
“SIMEAS P Parameterization” up to V01.30 is limited to SIMEAS P50 devices with
integrated display (7KG7750) because of additional communication parameters (refer
to chapter 1.2).
Note:
See Manual SIMEAS P 7KG7750/55 Device Manual, order no. E50417-B1076-C340,
for further information.