F
faults, 92
Faults
Electrical, 97, 98
Holding brake, 99
Inspection, 96, 103
Mechanical, 98
Roller bearings, 99
Feather key, 56
Five safety rules, 13
Fixing, 67
Flammable substances, 15
Flange-mounted motors, 65
Foundation surfaces, 53
G
General inspection, 103
Geometry of the flange, 53
H
Hazardous substances, 15
Hearing damage, 16, 34
Holding brake, 26, 137
Connection, 79
Faults, 99
Magnetic field, 84
Spare parts, 120
Hot surfaces, 15
Hotline, 131
I
Initial inspection, 105
Inlet temperature of the cooling water, 30
Inspection
Faults, 96, 103
Installation
Initial inspection, 103
Insulated bearings, 46
Insulation resistance, 50, 85, 104
Anti-condensation heating, 52
measure, 50
Interference immunity, 19
Interference voltages, 19
Interlocking circuit
Anti-condensation heating, 33
External fan, 33
L
Lifting, 37, 57
Line operation, 24
Long-term storage, 43
Low-Voltage Directive, 13
M
Machine
Mounting, 61
setting down, 60
Machine design, 23
IEC, 23
Magnetic fields, 16, 128
Main inspection, 105
Maintenance
Cooling system, 111
Maintenance intervals, 101
Maximum speed, 88
Flange mounting, 65
Minimum clearances, 72
Minimum radial forces, 27
Motor
Aligning, 63
Motor shaft, 81, 83, 92
Motor terminals, 81
Mounting
Flange, 65
Motor feet, 65
Mounting parts, 49
Mounting-foot hole dimensions, 53
N
Noise emissions, 16, 34
O
Operating mode, 29
Operating pressure, 66
Output element, 55
Overspeeds, 29
Index
SIMOTICS M-1PH8 1PH818., 1PH822.
194 Operating Instructions 07/2016
To Next Page
Loading...
Need help?
General