Siemens SIMOTION D410 DP User Manual

Interfaces
The SIMOTION D410 DP interfaces are described in the following tables.
Table 2-5
SIMOTION D410 interfaces
Interface Description
Digital inputs/outputs
X121
12-pin Mini Combicon:
●
4 digital inputs: for connecting switches or proximity sensors
● 4 digital inputs/outputs: for connecting actuators and sensors
DRIVE-CLiQ interface
X100
8-pin RJ45plus socket to connect DRIVE-CLiQ nodes
PROFIBUS DP interface
X21
9-pin SUB-D socket to connect to PROFIBUS DP
Power Module Interface
(PM-IF)
8-pin direct connector to connect to a blocksize power module
Encoder interface (HTL/TTL/
SSI)
X23
15-pin SUB-D socket for connecting HTL, TTL and SSI encoders.
EP terminals/temperature
sensor connection
X120
8-pin Mini Combicon for connecting Safety Integrated input terminals
or for connecting temperature sensing via KTY or PTC
Power supply connection
X124
4-pin screw terminal connection to connect the 24 V DC load power
supply
Measuring sockets
T0, T1, T2 and M
Sockets to output analog signals
Type plates
The following figure shows you all the information included on the type plate located on the
side of the unit.
0RGXOHGHVLJQDWLRQ
2UGHU1R
6HULDOQXPEHU
+DUGZDUHUHYLVLRQOHYHO
Figure 2-3 SIMOTION D410 nameplate
Description
2.3 SIMOTION D410 DP display
SIMOTION D410
Manual, 04/2014 27

Siemens SIMOTION D410 DP Specifications

General

Brand	Siemens
Model	SIMOTION D410 DP
Category	Control Unit
Language	English