6.3 CAD data, dimension drawings, and circuit-diagram macros
Dimension drawings and CAD data
Dimension drawings, as well as 2D and 3D CAD data can be found:
● In the CAD Creator (http://support.automation.siemens.com/WW/view/en/30559271)
●
In the DT Configurator (
http://www.siemens.com/dt-configurator) of the Industry Mall
Circuit-diagram macros
EPLAN circuit-diagram macros are available for SIMOTION D. The macros assist you when
creating circuit diagrams. The following address will take you to the macros (http://
support.automation.siemens.com/WW/view/en/31622426).
Dimension drawings
6.3 CAD data, dimension drawings, and circuit-diagram macros
SIMOTION D4x5-2
Manual, 04/2014 93
To Next Page
Loading...
