Configuration
3.1 Engineering software
Harmonics fed back into the line supply are calculated and graphically displayed.
The engineering results can be saved on a data medium, printed-out or copied into other
user programs for ongoing processing and editing through the clipboard.
PATH Plus is available with German/English user interfaces and screens.
The demonstration version of PATH Plus can be downloaded under the following Internet
address:
http://www.siemens.com/motioncontrol
(Products&Systems/Drive systems/Software), or simply use the fax form in the Appendix of
the Manual.
The full version of PATH Plus can be ordered from your local Siemens office under
Order No. 6SW1710-0JA00-2FC0.
General Section for Synchronous Motors
Configuration Manual, (PJAL), 11.2005 Edition, 6SN1 197-0AD07-0BP4
3-3
To Next Page
Loading...
