Siemens simovert masterdrives - Page 68

Index
R
Radial eccentricity tolerance, 2-3
Rated current, 1-7
Rated speed, 1-7
Rated torque, 1-7
Resistance characteristic, 5-12
S
Safety Guidelines, v
Shaft end, 2-2
Shaft torsional stiffness, 1-10
Signal lines, 4-7
Stall current, 1-7
Standard engineering, 3-2
Static torque, 1-7
Surface temperature, 2-2
T
Technical Support, iv
Temperature sensor, KTY 84, 5-11
Thermal limiting characteristic, 1-3
Thermal motor protection, 5-11
Thermal time constant, 1-10
Tolerance data, 1-11
Torque characteristics, 1-2
Torque constant, 1-9
V
Vibration severity, 2-3
Voltage constant, 1-10
W
Winding resistance, 1-10
General Section for Synchronous Motors
Index-2 Configuration Manual, (PJAL), 11.2005 Edition, 6SN1 197-0AD07-0BP4