Siemens simovert masterdrives User Manual

10.99 Faults and Alarms
Siemens AG 6SE7087-6KP50
SIMOVERT MASTERDRIVES Operating Instructions 12-27
Number / Alarm Cause Counter-measure
A195
Negative overtravel
reached
-Negative software limit switch position
approached
-"Software limit switches - negative" (machine
data 12) entered incorrectly
-The programmed position is less than the
negative software limit switch.
-"Reference point - coordinate" (machine data
3) is less than the negative software limit
switch.
-Incorrect encoder actual value
Effect:
The axis movement is stopped via the
deceleration ramp.
-Check the machine data and the NC program.
-Check the encoder actual value.
A196
Positive overtravel
reached
-Positive software limit switch position
approached
-"Software limit switches - positive" (machine
data 13) entered incorrectly¨
-The programmed position is greater than the
positive software limit switch
-"Reference point - coordinate" (machine data
3) is greater than the positive software limit
switch
-Incorrect encoder actual value
Effect:
The axis movement is stopped via the
deceleration ramp.
-Check the machine data and the NC
programs.
-Check the encoder actual value.
A200
No position has been
programmed in
Automatic mode
No position has been programmed in the NC
block for the roll feed version, although the
axis number of the roll feed is specified.
Effect:
NC program execution is inhibited or aborted,
the axis is brought to a standstill via the
deceleration ramp.
The axis number and the positional value must
be specified in every NC block for the roll feed
version.
A201
No velocity has been
programmed in
Automatic mode
The decoded NC block needs a path or axis
velocity.
Effect:
NC program execution is inhibited or aborted,
the axis is brought to a standstill via the
deceleration ramp.
When using linear interpolation with path
velocity (G01), a path velocity must be defined
with F. When using chaining with axis velocity
(G77), the axis velocities must be defined with
FX, FY, etc. When using roll feed with axis
velocity (G01), the velocity must be defined
with F.

Siemens simovert masterdrives Specifications

General

Brand	Siemens
Model	simovert masterdrives
Category	DC Drives
Language	English