Siemens simovert masterdrives User Manual

Faults and Alarms 10.99
6SE7087-6KP50 Siemens AG
12-26 Operating Instructions SIMOVERT MASTERDRIVES
Number / Alarm Cause Counter-measure
A181
Prog.no. of block
search forward level 2
<> cmd.
The subprogram number transferred with
block search for level 2 is not the same as the
subprogram number in the NC block.
Effect:
NC program execution is inhibited.
For the block search function, the subprogram
number specified in the NC block must be
specified as the subprogram number for level
2.
A183
Block no. of block
search fwd l. 0 does
not exist
The block number for the main program (level
0), which was transferred with block search,
does not exist in the main program.
Effect:
NC program execution is inhibited.
For the block search function, an existing
block number must be specified as the block
number for the main program.
A184
Block no. of block
search forward is no
UP call
The block number for the main program (level
0), which was transferred with block search,
does not contain a subprogram call for
subprogram level 1.
Effect:
NC program execution is inhibited.
For the block search function, a block number
with a subprogram call must be specified as
the block number for the main program (level
0) if a block search is to be performed in
subprogram level 1.
A185
Block no. of block
search forward does
not exist
The block number for subprogram level 1,
which was transferred with block search, does
not exist in the subprogram.
Effect:
NC program execution is inhibited.
For the block search function, a block number
which exists in this subprogram must be
specified as the block number for subprogram
level 1.
A186
Block no of block
search fwd level 1 is no
UP call
The block number for subprogram level 1,
which was transferred with block search, does
not contain a subprogram call for subprogram
level 2.
Effect:
NC program execution is inhibited.
For the block search function, a block number
with a subprogram call must be specified as
the block number for subprogram level 1 if a
block search is to be performed in subprogram
level 2.
A187
Block no. of block
search forward does
not exist
The block number for subprogram level 2,
which was transferred with block search, does
not exist in the subprogram.
Effect:
NC program execution is inhibited.
For the block search function, a block number
which exists in this subprogram must be
specified as the block number for subprogram
level 2.
A188
Remaining no of loops
block search fwd not
allowed
The remaining loop count transferred with
block search for subprogram level 1 or 2 is
greater than the programmed loop count.
Effect:
NC program execution is inhibited.
For the block search function, it is only allowed
to specify a remaining loop count between 0
and the programmed loop count-1.
A190
Digital input not
programmed
The NC block which was read in contains the
"inprocess measurement" or "set actual value
on-the-fly" function, although a digital input
has not been programmed for this function
(machine data 45).
Effect:
NC program execution is inhibited or aborted,
the axis is brought to a standstill via the
deceleration ramp.
Program the digital input for the desired
function.
A191
Digital input not
actuated
Although the "external block change" function
was programmed, the digital input was not
actuated in order to trigger the external block
change.
Effect:
The NC program is interrupted, the axis is
brought to a standstill via the deceleration
ramp.
-Correct the program.
-Check the actuation of the digital input.

Siemens simovert masterdrives Specifications

General

Brand	Siemens
Model	simovert masterdrives
Category	DC Drives
Language	English