Siemens simovert masterdrives User Manual

10.99 Faults and Alarms
Siemens AG 6SE7087-6KP50
SIMOVERT MASTERDRIVES Operating Instructions 12-25
Number / Alarm Cause Counter-measure
A170
Single block mode
block does not exist
An NC block was started in single-block mode
although a block has not yet been transferred.
Effect:
NC block execution is inhibited.
Transfer the block.
A172
Program with this
number does not exist
The program number specified in [PROG_NO]
for automatic mode is not stored in the
memory of the technology.
Effect:
NC program execution is inhibited.
-Transfer the program to the technology.
-Select the correct program number.
A173
Program number not
allowed
The program number specified in [PROG_NO]
for automatic mode is not allowed.
Effect:
NC program execution is inhibited.
The permissible range for program numbers is
between 1 and 200.
A174
Program number
changed during
traversing
The program number [PROG_NO] was
changed while the program was running.
Effect:
NC program execution is aborted and the axis
or axes are brought to a standstill via the
deceleration ramp.
The program number must not be changed
while the program is running.
A175
No block end
programmed
The decoded NC block is not terminated with
the following block identifier "0".
You can use the "output actual values -
decoder error location" task to read out the
program number and block number where the
block decoder detected an error.
Effect:
NC program execution is inhibited or aborted.
Moving axes are stopped via the deceleration
ramp.
Correct the block.
The last block in the sequence must contain
the following block identifier "0".
A177
Prog. number of block
search forwd. does not
exist
The program number for the main program
(level 0), which was transferred with the block
search function, does not exist.
Effect:
NC program execution is inhibited.
Specify an existing main program number.
A178
Program number of
block search forward
not allowed
-The program number for the main program
(level 0), which was transferred with block
search, is different from the selected program
number.
-No breakpoint is known for the "automatic
block search" function (a program abort has
not yet occurred).
-A different program number is stored as the
breakpoint for the "automatic block search"
function.
Effect:
NC program execution is inhibited.
For the block search function, the selected
program number [PROG_NO] must be
specified as the program number for the main
program.
A179
Prog.No.of block srch
fwd level 1/2 does not
exist
The subprogram number specified with block
search for level 1 or level 2 does not exist.
Effect:
NC program execution is inhibited.
For the block search function, an existing
program number must be specified as the
subprogram number for level 1 or level 2.
A180
Prog.no. of block
search forward level 1
<> cmd.
The subprogram number transferred with
block search for level 1 is not the same as the
subprogram number in the NC block.
Effect:
NC program execution is inhibited.
For the block search function, the subprogram
number specified in the NC block must be
specified as the subprogram number for level
1.

Siemens simovert masterdrives Specifications

General

Brand	Siemens
Model	simovert masterdrives
Category	DC Drives
Language	English