Siemens SINAMICS G120C Applications Manual

Using SINAMICS G120 / G120C / S120 Blocksize converters in marine applications
Application Manual, 11/2019, A5E48346362A
5
Safety information
1
WARNING
Not observing fundamental safety instructions and residual risks
If the basic safety instructions and residual risks are not carefully observed in the Power
Module documentation, accidents involving severe injuries or death may occur.
• Adhere to the fundamental safety instructions.
• When assessing the risk, take into account residual risks.
WARNING
Improper transport or installation of the Power Modules
Serious injury, or even death and substantial material damage can occur if the Power
Modules are not transported or installed properly.
• Transport, install and remove the Power Modules only if you are fully qualified to do so.
• Take into account that in some cases the Power Modules are heavy and top-heavy –
and take the necessary precautionary measures.
• Always secure the Power Modules when installing or removing by securely attaching
them to crane hooks.
• Wear your personal protection equipment (e.g. safety shoes, gloves).

Siemens SINAMICS G120C Specifications

General

Communication Interfaces	PROFINET, PROFIBUS, USS, Modbus RTU
Protection Class	IP20
Ambient Temperature	-10°C to +50°C
Storage Temperature	-40°C to +70°C
Power Range	0.55 kW to 132 kW
Voltage Range	380 V to 480 V
Output Voltage	0 V to Supply Voltage
Frequency Range	0 Hz to rated output frequency
Control Modes	Vector control with encoder
Protection	Overload, overvoltage, undervoltage, short circuit, ground fault
Relative Humidity	5% to 95%, non-condensing
Altitude	Up to 2000 m without derating