Tool offsets
8.14 Tool length compensation for orientable toolholders (TCARR, TCOABS, TCOFR)
Fundamentals
8-64 Programming Manual, 10.2004 Edition, 6FC5 298-7AB00-0BP1
;
;
=
=
,
,
,
After a reset, e.g., through manual setting or change of the toolholder with a fixed spatial
orientation, the tool length components also have to be determined again. This is performed
using the TCOABS and TCOFR path commands.
It is possible for an orientable toolholder of an active frame to determine the direction of the
tool when a tool is selected with TCOFRZ, TCOFRY, and TCOFRX.
Programming
TCARR=[m]
or
TCOABS
or
TCOFR
or
TCOFRZ, TCOFRY, TCOFRX
Parameters
TCARR=[m] Request toolholder with the number "m"
TCOABS Determine tool length components from the orientation of
the current toolholder
TCOFR Determine tool length components from the orientation of
the active frame
TCOFRZ Orientable toolholder from active frame with a tool
pointing in the Z direction
TCOFRY Orientable toolholder from active frame with a tool
pointing in the Y direction
TCOFRX Orientable toolholder from active frame with a tool
pointing in the X direction
To Next Page
Loading...
