Siemens SINUMERIK 828D Training Manual

SINUMERIK 828D Page 5 B060
Notes
Section 3
PPU2xx.1 with integrated 828D controller
Part numbers
General Information.
The PPU type can be identified by the PPU number:-
PPU2xx.1
0 - Vertical
1 - Horizontal
6 - Standard
8 - Performance
PPU Horizontal layout:-
Standard version
6FC5370-5AA00-0AA0 PPU261.1 without system software.
Performance version
6FC5370-7AA00-0AA0 PPU281.1 without system software.
PPU Vertical layout:-
Standard version
6FC5370-6AA00-0AA0 PPU260.1 without system software.
Performance version
6FC5370-8AA00-0AA0 PPU280.1 without system software.
Software (Current system software delivered on CF card):-
Milling (Max 6 axes)
6FC5831-2GY00-0YA0 Standard for PPU260/PPU261
6FC5830-2GY00-0YA0 Performance for PPU280/PPU281
Turning
6FC5831-1GY00-0YA0 Standard for PPU260/PPU261
6FC5830-1GY00-0YA0 Performance for PPU280/PPU281 (Max 8 axes with NX10)
Specifications
Input voltage- 24V DC +20% /-15%
Power Consumption 60W
Protection –Front operator panel IP65
Rear of PPU IP20
Operational temperature 0-45 °C
Operational Relative humidity 5 to 90 % @ 25°C (No condensation)
Horizontal model Vertical model
Width 310mm(12.2 in) 483mm (19 in)
Height 380mm(15in) 220mm (8.66 in)
Depth 105mm(4.13 in) 105mm( 4.13 in)
Hardware information

Siemens SINUMERIK 828D Specifications

General

Control Type	CNC
Operating System	Windows Embedded
Processor	Intel Atom
Display	10.4" color TFT display
Interfaces	Ethernet, USB
Programming	ShopMill, ShopTurn
Operation Panel Size	10.4"
Protection Class	IP65
PLC Memory	2 MB
Spindle Capacity	4 spindles
Hard Drive	CompactFlash