Siemens Sinumerik 840 sl Operation/Programming

0
10.04 Preface
0
 Siemens AG, 2004. All rights reserved
SINUMERIK 840D/840Di/810D Operation/Programming ShopMill (BAS) – 10.04 Edition ix
"Unit of measurement"
The parameter units are always specified in metric units in this
documentation. The corresponding inch measures are given in the
table below.
Metric Inch
mm in
mm/tooth in/tooth
mm/min in/min
mm/rev in/rev
m/min ft/min

Siemens Sinumerik 840 sl Specifications

General

Brand	Siemens
Model	Sinumerik 840 sl
Category	Control Unit
Language	English