List of Action Numbers 08/2005
3-970
© Siemens AG, 2005. All rights reserved
SINUMERIK 840D sl/840D/840Di/810D Diagnostics Guide (DA), 08/2005 Edition
No. 105
No. 106
No. 107
No. 108
No. 109
No. 115
Explanation Continuation of a single-axis movement (VDI signal).
Not allowed if The axis has not been stopped previously. Not for all axis types at present.
Remedy -
Explanation Interruption of a single-axis movement (VDI signal).
Not allowed if the axis is not controlled by the PLC. Not for all axis types at present.
Remedy -
Explanation Deletion of distance-to-go of a single-axis movement (VDI signal).
Not allowed if the axis is not controlled by the PLC. Not for all axis types at present.
Remedy -
Explanation Activation: Axis is now controlled by the PLC (VDI signal).
Not allowed if the axis is not controlled by the PLC. Not for all axis types at present.
Remedy -
Explanation Deactivate: Axis is now controlled by the PLC (VDI signal).
Not allowed if the axis is not controlled by the PLC. Not for all axis types at present.
Remedy -
Explanation The event is triggered by the positive PLC edge of the "Repos-Mode-Edge" signal.
Not allowed if The channel is active (program running, block search, loading machine data).
Remedy Abort the program with the Reset key or stop the program (not with block search, loading
machine data).
To Next Page
Loading...
Need help?
General
