Siemens SINUMERIK 840D sl - Page 964

List of Action Numbers 08/2005
3-964
© Siemens AG, 2005. All rights reserved
SINUMERIK 840D sl/840D/840Di/810D Diagnostics Guide (DA), 08/2005 Edition
No. 73
No. 74
No. 75
No. 76
No. 77
No. 78
Explanation Conditional stop at block end. If, after continuation by means of an NC Start, there is still
a reason to stop "Stop at block end", the program stops again.
Not allowed if -
Remedy -
Explanation Conditional stop at block end. (Despite the start, the interpreter or the preprocessing
does not manage to put a block in main run)
Not allowed if -
Remedy -
Explanation Stop preprocessing (alarm)
Not allowed if -
Remedy -
Explanation Retraction with G33 and Stop
Not allowed if -
Remedy -
Explanation Conditional wait for program marker (NC block: WAITMC).
Not allowed if -
Remedy -
Explanation Set marker (NC block: SETM).
Not allowed if -
Remedy -