er use
0
Siemens AG, 2002. All rights reserved
0-12 SINUMERIK 840D/840Di/810D Operator's Guide CAD Reader (CAD) – 03.02 Edition
Principle
Your SIEMENS 840D/840Di/810D has been designed and constructed
according to state-of-the-art technology and approved safety
regulations and standards.
Additional equipment
The applications of SIEMENS controls can be expanded by adding
special additional devices, equipment and expansions supplied by
SIEMENS.
Personnel Only appropriately trained, authorized and reliable personnel may
be allowed to operate this equipment. No-one without the necessary
training must be allowed to operate the control, even temporarily.
The corresponding responsibilities of personnel who set up, operate
and maintain the equipment must be clearly defined and adherence to
these responsibilities monitored.
Procedure Before the control is started up, the personnel who will work on the
control system must become thoroughly acquainted with the
Operator's Guide. It is also the duty of the equipment operator to
constantly monitor the overall technical condition of the control
(outwardly apparent defects or damage as well as changes in
operating performance).
To Next Page
Loading...
Need help?
General
