Siemens SINUMERIK 840Di - Scope of Application; Software

1
03.02 Introduction
1.2 General function
1
© Siemens AG, 2002. All rights reserved
SINUMERIK 840D/840Di/810D Operator's Guide CAD Reader (CAD) – 03.02 Edition 1-17
1.2.1 Scope of application
Scope of application
The CAD Reader is suitable for the following HMI target systems:
• HMI Advanced or HMI Embedded (Standard) SW 5.1 and higher
• ShopMill SW 5.3 and higher
• ShopTurn SW 6.2 and higher
• ManualTurn SW 5.3 and higher
DXF files converted by the CAD Reader program can be processed by
NC controls with G code programming such as SINUMERIK
840D/840Di/810D.
Notes
• The HMI Advanced or HMI Embedded (standard) target system,
ShopMill, ShopTurn or ManualTurn must be defined before the
contour is traced.
• When ShopMill or ShopTurn is defined as the target system, you
are prompted to enter a contour name before the contour is
traced.
• Please observe the boundary conditions applicable to the relevant
target system. This applies in particular to the number of contour
elements as regards the geometry processor or cycles.
Further information about suitable HMI target systems:
/BAD/, HMI Advanced Operator's Guide
/BEM/, HMI Embedded Operator's Guide
/BAS/, ShopMill Operator's Guide
/BAT/, ShopTurn Operator's Guide
/BAM/, ManualTurn Operator's Guide
1.2.2 Software
Software
The software is compatible with operating systems Microsoft
Windows 95, Windows 98, Windows Me, Windows NT 4.0 and
Microsoft Windows 2000.