Siemens SINUMERIK 840Di - Drill Points; Manipulate Graphic Display

2
03.02 How to Use the CAD Reader
2.4 Drill
p
oints
2
 Siemens AG, 2002. All rights reserved
SINUMERIK 840D/840Di/810D Operator's Guide CAD Reader (CAD) – 03.02 Edition 2-23
2.4 Drill points
Set drill points
1. Full circle as drill hole
You can select a full circle with the Drill Points function. The G
code generated is output in the cycle format.
Any Position
Row of Holes
Hole Circle
Hole Matrix
Drill points start
2. You can select the drill pattern to parameterize drill points as
• any drill positions
• according to cycle
• according to cycle
• according to cycle.
For further information about drill cycles and drill patterns, please see:
/PGZ/, Programming Guide Cycles, Chapter 2
Drill points end
3. This button accepts drill points selected from the drill pattern.
2.5 Manipulate graphic display
Select the processing area:
If the file contains a large number of supplementary drawings such as
cuts, hatching, labeling, detail views, borders, etc., you can reduce the
number of elements by using a "lasso" to select a processing area.
Deselect the processing area:
You can click this button to deselect the processing area again.