orted file
2
Siemens AG, 2002. All rights reserved
SINUMERIK 840D/840Di/810D Operator's Guide CAD Reader (CAD) – 03.02 Edition 2-25
Turn contour
This button rotates the drawing by 90 degrees each time about the
defined zero point according to the default settings. Existing contours
are not rotated at the same time.
Show hatching and dimensions
This button shows or hides hatching and dimensions in CAD drawings.
The function is reset again when you click the button again.
Delete contour trace
You can select and completely delete contours that are already
defined. The "Delete contour" function is activated when you select
this button once and deactivated when you click it again. Delete
finished contours:
• Click button: Activate "Delete contour"
• Select contour: Contour is deleted
Delete geometry element
You can use this function to delete individual geometry elements. It is
activated when you click the button once and deactivated when you
click it again. Delete geometry element:
• Click button: Activate "Delete geometry element"
• Select element: Geometry element is deleted
Delete geometry area
A whole area selected by a rectangle drawn with the mouse (defining
the area to be deleted) can be deleted from the geometry when you
click this button. Every time you delete an area, the function is
automatically deactivated and must be re-activated explicitly via this
button.
• Select button: Activate "Delete geometry area"
• Select area: Geometry area is deleted
To Next Page
Loading...
