lication for a contour trace
4
Siemens AG, 2002. All rights reserved
SINUMERIK 840D/840Di/810D/ Operator's Guide CAD Reader (CAD) – 03.02 Edition 4-33
Layer selection view
CAD Reader for layer "1" in optimized display form.
Contour trace with start and end points
Click this button to start the contour trace and select "Element center"
in the selection menu which then appears.
Move the mouse to the desired start element and select the direction
with the mouse (always click the small triangle). Move the arrow with
the mouse in the right direction and select the next corner point.
Element center
Select the element center and contour trace in direction of arrow.
To Next Page
Loading...
