© Siemens AG, 2002. All rights reserved
SINUMERIK 840D/840Di/810D Operator's Guide CAD Reader (CAD) – 03.02 Edition A-41
S3 Synchronous Spindles
S5 Synchronized Actions (up to SW 3/ thereafter /FBSY/)
S6 Stepper Motor Control
S7 Memory Configuration
T1 Indexing Axes
W3 Tool Change
W4 Grinding
/FB3/
SINUMERIK 840D/840Di/810D(CCU2)
Description of Functions, Special Functions (Part 3) (08.02 Edition)
(the various sections are listed below)
Order No.: 6FC5 297-6AC80-0BP2
F2 3-Axis to 5-Axis Transformation
G1 Gantry Axes
G3 Cycle Times
K6 Contour Tunnel Monitoring
M3 Coupled Motion and Leading Value Coupling
S8 Constant Workpiece Speed for Centerless Grinding
T3 Tangential Control
TE1 Clearance Control
TE2 Analog Axis
TE3 Speed/Torque Coupling Master-Slave
TE4 Transformation Package Handling
TE5 Setpoint Exchange
TE6 MCS Coupling
TE7 Retrace Support
TE8 Clock-Independent Path-Synchronous Output of Switching Signal
V2 Preprocessing
W5 3D Tool Radius Compensation
/FBA/
SIMODRIVE 611D/SINUMERIK 840D/810D
Description of Functions Drive Functions (08.02 Edition)
(the various sections are listed below)
Order No.: 6SN1 197-0AA80-0BP9
DB1 Operational Messages/Alarm Reactions
DD1 Diagnostic Functions
DD2 Speed Control Loop
DE1 Extended Drive Functions
DF1 Enable Commands
DG1 Encoder Parameterization
DM1 Calculation of Motor/Power Section Parameters and Controller Data
DS1 Current Control Loop
DÜ1 Monitors/Limitations
To Next Page
Loading...
