5 Configuring 11.92
5.13 FB 139 Data distributor
Error messages which lead to job abort:
Package 5 Data distributor
3200 1: Job initiation during valid job processing
3201 2: Illegal command code
3202 3: Magazine not available
3203 4: Magazine location not available
3204 5: Cutting edge number not available
3205 6: Number of cutting edges to be loaded does not correspond to
setup data
3206 7: Cutting edges are not loaded in ascending order
3207 8: Reloading: Tool defined by ID and Duplo number not found
3208 9: Out of area on TO data access
3209 10: TO memory full
3210 11: Abort because of power failure; entered tool data are deleted
3211 12: Magazine and/or locator number changed while loading several
cutting edges
3212 13: Insufficient number of adjacent locations (only for magazines
without configuration)
3213 14: No further tool is to be reported in the magazine
3214 15: Reference list was preset incorrectly
3215 16: Reloading into tool buffer not possible
3216 17: D No. was already entered
3217 18: Magazine location disabled, reserved or occupied by another tool
3218 19: No loading memory defined
3219 20: Tool buffer is not allocated to any magazine/channel Global
tool buffer
3220 21: Loading with operator guidance is not permissible
(DB 146, D1.0 = 1)
3221 22: No ready signal from operator panel
3222 23: Loading with operator guidance was aborted
(neg. acknowledgement DB 146, D1.1 =1)
3223 24: Machine data "Magazine number for loading with operator
guidance" not defined (DB 146, DW 136 = 0)
5–52 © Siemens AG 1991 All Rights Reserved 6FC5 197-0AA40-1BP1
SINUMERIK 840/880 (PJ)
To Next Page
Loading...
