Siemens SINUMERIK ONE MCP 2400.4c Operation/Programming

3
Machining the Workpiece 08/2005
3.7 Overstorin
g
3
© Siemens AG, 2005. All rights reserved
3-104 SINUMERIK 840D sl Operation/Programming ShopTurn (BAT) – 08/2005 Edition
After "Overstore", a subroutine with the content REPOSA, which you
can observe, is executed.
Overstore without single
block
 Load a program in "Machine Auto" operating mode (see Sec.
"Selecting a program for execution").
Cycle Stop
 Press the "Cycle Stop" key.
 Press the "Overstore" softkey.
The "Overstore" window is opened.
 Enter the NC blocks to be processed.
Cycle Start
 Press the "Cycle Start" key.
The blocks you have entered are stored. You can observe execution
of the blocks in the "Overstore" window.
After the entered blocks have been executed, you can append blocks
again.
Stopping overstore
 Press the "Back" key to exit "Overstore".
The window is closed.
You can switch modes now.
Cycle Start
After you have pressed "Cycle Start" again, the selected program
continues before overstore.

Siemens SINUMERIK ONE MCP 2400.4c Specifications

General

Brand	Siemens
Model	SINUMERIK ONE MCP 2400.4c
Category	Control Systems
Language	English