0
08/2005 Contents
0
♥ Siemens AG, 2005. All rights reserved
SINUMERIK 840D sl Operation/Programming ShopTurn (BAT) – 08/2005 Edition xiii
6.2 Zero-point offsets....................................................................................................6-335
6.3 Simple workpiece machining in manual mode ....................................................... 6-335
6.3.1 Traversing the axes ................................................................................................6-336
6.3.2 Taper turning........................................................................................................... 6-337
6.3.3 Straight turning........................................................................................................ 6-338
6.4 More complex machining in manual mode.............................................................6-339
6.4.1 Drilling with manual machine..................................................................................6-340
6.4.2 Turning with manual machine.................................................................................6-340
6.4.3 Milling with manual machine................................................................................... 6-341
6.5 Simulation ............................................................................................................... 6-341
G Code Program 7-343
7.1 Creating a G-code program....................................................................................7-344
7.2 Executing a G-code program..................................................................................7-347
7.3 G-code editor ..........................................................................................................7-349
7.4 Calculation parameters...........................................................................................7-352
Tool Management 8-353
8.1 Tool lists, tool wear lists and the tool magazine .....................................................8-354
8.2 Importing tools into the tool list ...............................................................................8-360
8.2.1 Creating a new tool.................................................................................................8-360
8.2.2 Creating several cuts per tool.................................................................................8-362
8.2.3 Creating a sister tool...............................................................................................8-363
8.3 Sorting tools ............................................................................................................ 8-364
8.4 Deleting tools from the tool list................................................................................8-364
8.5 Loading/unloading a tool into/out of the magazine.................................................8-365
8.6 Relocating a tool .....................................................................................................8-367
8.7 Positioning the magazine........................................................................................ 8-369
8.8 Inputting tool wear data........................................................................................... 8-369
8.9 Activating tool monitoring........................................................................................ 8-370
8.10 Managing magazine locations ................................................................................8-372
Program Management 9-373
9.1 Managing programs with ShopTurn........................................................................ 9-374
9.2 Managing programs with ShopTurn on NCU (HMI Embedded).............................9-375
9.2.1 Opening a program................................................................................................. 9-377
9.2.2 Executing a program............................................................................................... 9-378
9.2.3 Executing a G-code program from the USB-network-drive.................................... 9-379
9.2.4 Creating a Nnew directory/program........................................................................9-380
9.2.5 Marking several programs ...................................................................................... 9-381
To Next Page
Loading...
Need help?
General
