5
ShopTurn Functions 08/2005
5
♥ Siemens AG, 2005. All rights reserved
5-154 SINUMERIK 840D sl Operation/Programming ShopTurn (BAT) – 08/2005 Edition
5.5.1 Rectangular pocket .................................................................................................5-236
5.5.2 Circular pocket.........................................................................................................5-240
5.5.3 Rectangular spigot ..................................................................................................5-243
5.5.4 Circular spigot..........................................................................................................5-247
5.5.5 Longitudinal slot.......................................................................................................5-250
5.5.6 Circumferential slot..................................................................................................5-253
5.5.7 Positions..................................................................................................................5-257
5.5.8 Multiple edge ...........................................................................................................5-258
5.5.9 Engraving ................................................................................................................5-260
5.6 Contour milling ........................................................................................................5-267
5.6.1 Representation of the contour.................................................................................5-270
5.6.2 Creating a new contour ...........................................................................................5-272
5.6.3 Creating contour elements ......................................................................................5-274
5.6.4 Changing a contour.................................................................................................5-281
5.6.5 Path milling..............................................................................................................5-283
5.6.6 Predrilling a contour pocket.....................................................................................5-288
5.6.7 Milling a contour pocket (roughing).........................................................................5-292
5.6.8 Removing residual material from a contour pocket.................................................5-295
5.6.9 Finishing the contour pocket ...................................................................................5-297
5.6.10 Chamfering a contour pocket ..................................................................................5-301
5.6.11 Milling a contour spigot (roughing) ..........................................................................5-302
5.6.12 Removing residual material from a contour spigot..................................................5-305
5.6.13 Finishing the contour spigot ....................................................................................5-307
5.6.14 Chamfering a contour spigot ...................................................................................5-310
5.7 Calling a subroutine.................................................................................................5-312
5.8 Repeating program blocks ......................................................................................5-314
5.9 Machining with the counterspindle..........................................................................5-315
5.10 Changing program settings.....................................................................................5-321
5.11 Calling work offsets.................................................................................................5-322
5.12 Defining coordinate transformations .......................................................................5-323
5.13 Programming the approach/return cycle.................................................................5-326
5.14 Inserting G code into the sequential control program .............................................5-327
5.15 Teaching..................................................................................................................5-329
5.15.1 Teaching a cycle......................................................................................................5-329
5.15.2 Teaching a position sample.....................................................................................5-330
5.15.3 Teaching a contour object.......................................................................................5-331
To Next Page
Loading...
Need help?
General
