<Cursor up>
● Editing box
Moves the cursor into the next upper field.
● Navigation
– Moves the cursor in a table to the next cell upwards.
– Moves the cursor upwards in a menu screen.
<Cursor up> + <Ctrl>
● Moves the cursor in a table to the beginning of the table.
● Moves the cursor to the beginning of a window.
<Cursor up> + <SHIFT>
In the program manager and in the program editor, selects a contig‐
uous selection of directories and program blocks.
<Cursor down>
● Editing box
Moves the cursor downwards.
● Navigation
– Moves the cursor in a table to the next cell downwards.
– Moves the cursor in a window downwards.
<Cursor down> + <CTRL>
● Navigation
– Moves the cursor in a table to the end of the table.
– Moves the cursor to the end of a window.
● Simulation
Reduces the override.
<Cursor down> + <SHIFT>
In the program manager and in the program editor, selects a contig‐
uous selection of directories and program blocks.
<SELECT>
Switches between several specified options in selection lists and in
selection boxes.
Activates checkboxes.
In the program editor and in the program manager, selects a program
block or a program.
<SELECT> + <CTRL>
When selecting table rows, switches between selected and not se‐
lected.
<SELECT> + <SHIFT>
Selects in selection lists and in selection boxes the previous entry
or the last entry.
<END>
Moves the cursor to the last entry field in a window, to the end of a
table or a program block.
Selects the last entry in selection lists and in selection boxes.
Introduction
2.2 Operator panel fronts
Milling
30 Operating Manual, 08/2018, 6FC5398-7CP41-0BA0
To Next Page
Loading...
Need help?
General
