Siemens SIPART Series - Checking the Consignment; Transportation and Storage

See also
Catalog process instrumentation (http://www.siemens.com/processinstrumentation/catalogs)
Product information on SIPART PS2 in the Internet (http://www.siemens.com/sipartps2)
1.2 History
The following table shows the most important changes in the documentation compared to the previous edition.
Edition Comment
01/2012 Diverse changes to the instructions due to a certificate update
1.3 Checking the consignment
Check the device packaging for damage. Inform your supplier of any damage. Retain the damaged parts for clarification.
Check the scope of delivery by comparing the shipping documents with your order for correctness and completeness.
Do not take damaged or incomplete devices into operation under any circumstances.
Special conditions for storage and transportation of device listed in Section "Technical specifications (Page 31)".
1.4 Design of the nameplate
Design of the nameplate










'511
61R$
① Manufacturer ⑥ FM/CSA marking for hazardous area
② Approvals ⑦ Consult operating instructions
③ ATEX/IECEx marking for hazardous area ⑧ Place of manufacture
④ Order number ⑨ Safety class
⑤ Manufacturer serial number ⑩ Product name
Figure 1-1 Nameplate layout, example
1.5 Transportation and storage
To guarantee sufficient protection during transport and storage, observe the following:
● Keep the original packaging for subsequent transportation.
● Devices/replacement parts should be returned in their original packaging.
● If the original packaging is no longer available, ensure that all shipments are properly packaged to provide sufficient
protection during transport. Siemens cannot assume liability for any costs associated with transportation damages.
SIPART PS2 Non-Contacting Sensor (NCS)
A5E00097485-07, 01/2012
19