Getting Started
4.3 CFC
3. Enter input address, in this case: IW0.
4. Confirm input value by pressing enter. Now the blocks input address is connected to the
devices input address.
1. Please note the following label in the CFC-Template. This is a reminder that you need to
wire the output address of the Soft Starter device manually.
2. Right click on output pin OUT_01 of block SS_DIR and select “Interconnection to
Address…”
PCS 7 Library Soft Starter 3RW44 "V6.2" / "V7.1" / "V8 Migration V8.0+SP2
Getting Started, 05/2015, A5E02897713020A/RS-AB/004
21
To Next Page
Loading...
