The Getting Started of the PCS 7 library for SIRIUS soft starter uses a simple example
project to show you the basic procedures:
● Basic configuration steps
● Handling and monitoring different signal blocks
● Parameterization
This Getting Started serves as an introduction and largely dispenses with detailed
information and background information.
Basic knowledge of how to create a PCS 7 project. You can find information on creating a
project in the following documents:
● For PCS 7 V6.1:
"SIMATIC PCS 7 Process Control System V6.0 Getting Started - First Steps
Documentation"
● For PCS 7 V7.0:
"SIMATIC PCS 7 Process Control System V7.0 Getting Started - First Steps
Documentation"
● For PCS 7 V7.1:
"Process Control System PCS 7 Getting Started Part 1 (V7.1)"
"Process Control System PCS 7 Getting Started Part 2 (V7.1)"
● For PCS 7 V8.0:
"Process Control System PCS 7 Getting Started Part 1 (V8.0)"
"Process Control System PCS 7 Getting Started Part 2 (V8.0)".
This documentation contains designations of the software interface elements. If you have
installed a multi-language package for the operating system, some of the designations will
be displayed in the base language of the operating system after a language switch and will,
therefore, differ from the designations used in this documentation.
PCS 7 Library Soft Starter 3RW44 "V6.2" / "V7.1" / "V8 Migration V8.0+SP2
Getting Started, 05/2015, A5E02897713020A/RS-AB/004
7
To Next Page
Loading...
