Getting Started
5.3 CFC
SIRIUS Soft Starter 3RW44 PCS 7 Library V8.2
22 Getting Started, 07/2016, A5E36563533002A/RS-AA/001
1. Scroll to the left, till you see the sheet bar. There you will find a textual interconnection
named
Input address of 3RW44 Soft Starter device
.
Now you have two options:
– Setting the HW input address manually, as seen in HW-Config.
– Use symbol table for selecting the input address.
Since this is a short example, we will just hand over the devices input address as it is
displayed in HW-Config. We recommend using the symbol table for large projects. Refer
"SIMATIC Process Control System PCS 7 Engineering System
(https://support.industry.siemens.com/cs/document/109485969
)".
2. Right click on
Input address of 3RW44 Soft Starter device
and select
Interconnection to
Address.
A symbol table like dialog opens.
Insert the input address, in this case:
.
3. Confirm the input value by pressing enter. Now the blocks input address is connected to
the devices input address.
To Next Page
Loading...
