To Next PageTo Next PageWhat does 'Backup error' mean on my Siemens SITRANS TS100?
If your Siemens Temperature Controller displays 'Backup error', it means a sensor error is detected at the backup sensor, and no backup is available. Unplug and reconnect the sensor cable. Check if the sensor is operated out of specified limits. If the problem persists, replace the sensor.
Why is 'Backup enabled' on my Siemens SITRANS TS100 Temperature Controller?
If your Siemens Temperature Controller displays 'Backup enabled', it means a sensor error is detected, and the backup sensor is in use. Unplug and reconnect the sensor cable. Check if the sensor is operated out of specified limits. If the problem persists, replace the sensor.
What does 'Drift detected' mean on my Siemens SITRANS TS100 Temperature Controller?
If your Siemens Temperature Controller displays 'Drift detected', it means the difference of the measured results between Input 1 and Input 2 lies above the configured maximum limit. Unplug and reconnect the sensor cable. If the problem persists, replace the sensor.
What does 'Input 2 CJC' mean on my Siemens SITRANS TS100 Temperature Controller?
If your Siemens Temperature Controller displays 'Input 2 CJC', it means a sensor error (broken/shorted sensor) is detected at the cold junction compensation measurement used for Input 2. Unplug and reconnect the sensor cable. If the problem persists, replace the sensor.
Why does my Siemens SITRANS TS100 display 'No symbol is displayed'?
If your Siemens Temperature Controller displays 'No symbol is displayed' and at least one process value violates one of the process tolerance limits set in the device parameters, check the parameter settings for limits for this application.
How to fix 'Input 2 error' on Siemens SITRANS TS100 Temperature Controller?
If your Siemens Temperature Controller displays 'Input 2 error', it means a sensor error (broken/shorted sensor) is detected at Input 2. Unplug and reconnect the sensor cable. If the problem persists, replace the sensor.
How to fix 'Input 1 error' on Siemens SITRANS TS100?
If your Siemens Temperature Controller displays 'Input 1 error', it means a sensor error (broken/shorted sensor) is detected at Input 1. Unplug and reconnect the sensor cable. If the problem persists, replace the sensor.
Why does my Siemens SITRANS TS100 Temperature Controller show an electronics temperature alarm?
If your Siemens Temperature Controller displays 'Electronics temperature alarm', it means the device is operated outside its specified temperature range. Check the operating temperature.
What does 'Non-primary variable out of limits' mean on my Siemens SITRANS TS100?
If your Siemens Temperature Controller displays 'Non-primary variable out of limits', it means a process value that is not mapped to the primary variable has reached the sensor limit. Review process conditions versus product specifications.
What does 'Primary variable out of limits' mean on my Siemens SITRANS TS100?
If your Siemens Temperature Controller displays 'Primary variable out of limits', it means the process value has reached the sensor limit. Review process conditions versus product specifications.
General| Accuracy | ±0.5 °C |
|---|---|
| Display | LCD |
| Protection Class | IP65 |
| Power Supply | 24 V DC |
| Input | RTD, Thermocouple |
| Control algorithm | PID |
| Approvals | ATEX, IECEx |
| Operating Temperature | -40 to +85 °C (-40 to +185 °F) |
| Temperature Range | -50 to +150 °C (-58 to +302 °F) |
| Output Signal | 4-20 mA, HART |
