Siemens SR23EI28ME User Manual

Troubleshooting en
47
Fault Cause troubleshooting
Water marks on plastic
parts.
Due to laws of physics
droplet formation on plastic
surfaces is unavoidable.
After drying water marks are
visible.
▶
Select a more intensive pro-
gramme.
→"Programmes", Page17
▶
Position tableware at an angle.
→"Arrange tableware", Page29
▶
Use rinse aid.
→"Rinse aid", Page25
▶
Set the water softening system
higher.
Wipeable or water-soluble
coatings are present inside
the appliance or on the door.
Detergent substances are
deposited there. These coat-
ings cannot generally be re-
moved with chemicals.
▶
Change your detergent →Page26.
▶
Clean the appliance mechanically.
White coating is deposited in
the appliance interior.
1. Set the water softening system cor-
rectly.
In most cases you will need to in-
crease the setting.
2. Change your detergent if required.
Special salt dispenser is not
screwed tight.
▶
Screw the special salt dispenser
tight.
Stubborn white coatings are
present on tableware, inside
the appliance or the door.
Detergent substances are
deposited there. These coat-
ings cannot generally be re-
moved with chemicals.
▶
Change your detergent →Page26.
▶
Clean the appliance mechanically.
The hardness range is set in-
correctly or the water hard-
ness is greater than 62°E
(8,9mmol/l).
▶
Set the Water softening system to
the water hardness or add special
salt.
3in1/organic/eco detergent
is not effective enough.
▶
Set the Water softening system to
the water hardness and use separ-
ate detergents (proprietary deter-
gent, special salt, rinse aid).
Too little detergent is being
used.
▶
Increase the amount of detergent
used or change Detergent
→Page26.
Washing programme selec-
ted too weak.
▶
Select a more intensive washing
programme.
→"Programmes", Page17
Tea residue or lipstick marks
on tableware.
Washing temperature is too
low.
▶
Select a programme with a higher
washing temperature.
→"Programmes", Page17

Siemens SR23EI28ME Specifications

General

Door color	Stainless steel
Cord length	1.75 m
Product size	Slimline (45 cm)
Inlet hose length	1.65 m
Custom panel-ready	Yes
Outlet hose length	2.05 m
Appliance placement	Freestanding
Current	10 A
AC input voltage	220-240 V
AC input frequency	50\\60 Hz
Energy efficiency scale	A to G
Water consumption per cycle	9.5 L
Cycle time	210 min
Noise level	44 dB
Delay start (max)	24 h
Overflow protection	-
Dishwashing programs	60min 65°C, Auto 45-65°C, Eco 50°C, Intensive 70°C, Standard 60°C
Number of place settings	10 place settings
Number of washing programs	6
Number of temperature settings	4
Package weight	43200 g

Weight and Dimensions

Depth	600 mm
Width	450 mm
Height	845 mm
Weight	41996 g
Depth with door open	1155 mm